After working on the circuit for few weeks, I decided to continue my project on working out on my radiator coil. This coil is the most important element in the project. Because, without that..I could not run the project, in other words..i couldn't induce sleep, how am I going to test my project, hehehehe...so, to create the radiator coil, what I did was by getting a 40 mm steel bolt with a 6mm diameter..and winding it with a 0.2mm enameled wire for about 600 turns. It takes time to wind the wire due to the wire is very thin and easy to break. So high concentration needed in order to wind it perfectly.
This is one of the technique used to wind the wires on the steel bolt.
No comments:
Post a Comment